Electrical

The next to the last item to be finished for Gerber is the wye control…

I discovered a short in Gerber Yard - all tracks!  Let's see, I changed the…

Tom Pearson came over on May 16 and again on the 30th and all feeders…

I've been slow in posting so I backdated a couple of entries to show when…

"Speed" Muller came over and helped troubleshoot the Arduino sketch.  Note that the pushbuttons have…

I had to make a few changes in how the panel would be constructed.  Instead…

I now have all my newer T1300 throttles at the expense of the older ones. …

All the throw rods were clipped off that extended too far. I spent a good…

You may have thought I gave up!  Busy doing other things - trip to California…

61 Tortoises have been installed in Gerber but not wired.  These came from my previous…

All the feeders have been installed for Gerber using 22-gauge wire.  The red and white…

I started installing Tortoises in Proberta.  I had hoped to use the same throw wire…

The basic backdrop was completed, and joints painted. This week I worked on creature comforts,…

The last couple of days were spent installing LED light strips (see picture below.)  15…